Snorkel TB50 - Manual (Page 46)

Chapter 7 – Prestart Inspection
42 TB42/TB50 – 0074923
Tow Kit
The machine may be equipped with an optional tow
kit.
• Inspect the components, including the tow bar, steer
arm, and chains, etc. to verify all components are
present and are in working condition.
Platform Glazier Package
To inspect the platform glazier package:
1. Inspect the glazier trays (refer to Figure 7.27) to
make sure they are in good condition and are not
bent or distorted.
2. Inspect the keeper pins to make sure they are in
good condition and are not bent or distorted.
Figure 7.27 – Platform
3. Make sure the straps and padding are in good condi-
tion and are not worn, cut or frayed.
Platform Control Cover
The machine may be equipped with an optional platform
control cover.
Inspect the cover to ensure it fits properly over the
control panel.
Placards and Decals
To inspect the placards and decals:
1. Inspect all safety and operational placards and
decals. Make certain they are in place, in good
condition, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be
seen.
Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer’s label for proper use and disposal.
Wear protective gloves and splash-proof safety
glasses when using solvents.
3. Remove wet paint overspray with a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing, damaged, or illegible placards
or decals before operating the aerial platform.
Placard and decal kits are available from Snorkel.
The safety related placards and decals are illustrated
on the following pages.

Keeper Pins
Straps
Padding
Trays