Snorkel XT24AL-sn10000+ - Manual (Page 37)

1/31/2008 - 38 -
Users shall keep and maintain a copy of the operation and maintenance manual stored in the
manual tube of the machine. These manual(s) are considered an integral part of the aerial platform
and are vital to communicate necessary safety information to users and operators.
Users shall inspect and maintain the aerial platform as required to ensure proper operation.
The frequency of inspection and maintenance shall be determined by the manufacturer's
recommendation and be compatible with operating conditions and the severity of the operating
environment. Aerial platforms that are not in proper operating condition shall be immediately
removed from service until repaired. Repairs shall be made by qualified personnel and the repairs
shall be in conformance with the manufacturer's recommendations.
An inspection as outlined in the Operations and Maintenance Manual shall be conducted.
An annual inspection shall be performed on the aerial platform no later than 13 months from
the date of the prior annual inspection. The inspection shall be made by a person qualified as a
mechanic on the specific make and model of the aerial platform. The inspection shall include all
items specified by the manufacturer for an annual inspection as listed in the Operations and
Maintenance Manual.
Before each day or at the beginning of each shift, the aerial platform shall be given a visual
inspection and functional test including but not limited to the following:
1. Operating and emergency controls
2. Safety devices
3. Personal protective devices, including fall protection
4. Air, hydraulic and fuel system leaks
5. Cables and wiring harness
6. Loose or missing parts
7. Tires and wheels
8. Placards, warnings and control markings
9. Outriggers, stabilizers, and other structures
10. Guardrail system
11. Items specified by the manufacturer
Before adjustments and repairs are started on an aerial platform, the following precautions shall be
applicable:
1. All controls in the "off" position and all operating features from inadvertent motion by
brakes, blocks, or other means.
2. Power source disconnected/stopped and starting means rendered inoperative
3. Platform lowered to the full down position, if possible, or otherwise secured by blocking or
cribbing to prevent dropping
4. Hydraulic oil pressure relieved from all hydraulic circuits before loosening or removing
hydraulic components