Snorkel XT24AL-sn10000+ - Manual (Page 28)

- 9 2 - 8 0 0 2 / 1 3 / 1
7. Test the switch by removing the outrigger retention pin, move the outrigger in and out while
the outrigger leg is held with slight upward pressure. The proximity switch should open and
close as the outrigger leg is moved in and out.
8. Extend the outrigger leg and replace the retention pin.
9. The proximity switch should be calibrated.
TESTING:
1. Ensure everything is properly adjusted by lowering the outrigger leg so as to slightly lift
the corner of the scissors jack. With a continuity tester check to see if there is continuity
across the contacts of the switches. If there is not continuity then the procedure must be
redone.
2. Next lift the outrigger leg so that there is no pressure on the leg. There should no longer
be continuity across the contacts on the pressure switch.
3. Pull the outrigger retention pin
4. Move the outrigger leg in about 5 cm.
5. Lower the outrigger leg until there is upward pressure.
6. test continuity across the proximity switch, there should be no continuity,
The outrigger should now be ready for use.
HYDRAULIC FLUID LEVEL/TYPE AND MAINTENANCE
1. Use ATF Mercon/Dexron-III fluid to refill unit
2. Check snap rings on scissors sections before each use. Replace any missing, broken or loose
nuts and bolts
3. Check and refill hydraulic fluid before each use. Fluid level should be 5 cm below top of fill
tube.
4. Check the tire pressure, hydraulic hose and electrical wires for abrasions and cuts before
each use. Replace damaged items.
5. Inspect outriggers and pins for damage and cracks before each use and once a year check
and grease wheel bearings
ROUTINE MAINTENANCE MANUAL
1. Inspect machine for any metal fatigue or wear. Do not use if any cracked welds are found.
Cease operation and contact UPRIGHT. if any defects are found. Refer to UPRIGHT
pre-delivery and inspection report for additional information