Snorkel XT24AL-sn10000+ User Manual

Page 29

1/31/2008 -

2. Check pinned connections on outriggers. The outrigger retaining pins are to be removed and

each outrigger is to be pulled out of its transport position. Replace the outrigger in a
vertical position so that the outrigger pad faces down. Replace the security pin from where
it was removed with the outrigger in its extended position. Always replace the spring loaded
security pin in each outrigger pin.

3. The outrigger is held in place with a hitch-type pin and a hairpin clip. Do not use if the pin

or clip is missing. Replace before use.

4. Check to see that the deck gate chain is in place. Do not use machine if the chain is missing.

Hydraulics – ATF Mercon/Dexron III Hydraulic Oil

1. Check hoses for any leaks or wear.
2. Check oil level in the reservoir. Oil level should be 2” below the top of fill tube when the

lift is fully lowered. Total oil capacity is 3 gallons. Do not overfill as this will result in fluid
discharge from the tank vent plug.

3. Vent plug on cylinder should be free of external debris. Do not use lift if vent plug on

cylinder is missing. Replace vent plug with factory supplied plug before use.

Scissors Stack

1. Check scissors stack connections for wear.
2. A washer and external snap ring hold stack sections in place. Do not operate lift if snap ring

or washer is missing. Replace before use.

3. Scissors stack sections require no lubrication

Battery

Proper battery condition is essential to good machine performance and operational safety.

Improper fluid levels or damaged cables and connections can result in component damage and
hazardous conditions.

1. Put on protective clothing and eyewear.
2. Be sure that the battery cable connections are free of corrosion.