Snorkel SPM20 CE-sn0001+ - Manual (Page 54)

51
SECTION 5. GENERAL SPECIFICATIONS AND OPERATOR
MAINTENANCE
5.1 INTRODUCTION
This section of the manual provides additional necessary information to the operator for
proper operation and maintenance of this machine.
The maintenance portion of this section is intended as information to assist the machine
operator to perform daily maintenance tasks only, and does not replace the more thorough
Preventive Maintenance and Inspection Schedule included in the Service and Maintenance
Manual.
Other Publications Available Specific to this Machine:
Service and Maintenance Manual
Illustrated Parts Manual
5.2 GENERAL SPECIFICATIONS
Machine Specifications
SPECIFICATION SPM20
Gross Machine Weight (Platform
Empty):
850kg 880kg 1100kg 1250kg
Machine Height (Platform Stowed): 198cm
Maximum Ground Bearing
Pressure: (per wheel)
360kg
Maximum Operating Incline: 1.5 °
Maximum Travel Grade (Grade
ability): (Platform STOWED ONLY)
15-20%
Maximum Travel Grade (Side
Slope): (Platform STOWED ONLY)
5 °
Maximum Drive Speeds (Operator
Variable):
0.6-4 km/h
Maximum Base – Overall: (Width x
Length)
76cm x 136cm 100cm x 150cm
Maximum Wind Speed: 0 km/h-Machine rated for indoor use only
Maximum Horizontal Manual Side
Force: (Platform fully extended with
Maximum load)
100 N 200 N
Maximum Hydraulic System
Pressure: (Recommended initial
setting)
12MPa
Hydraulic Reservoir Capacity: 5L 5L