Snorkel SPM20 CE-sn0001+ - Manual (Page 39)

36
Activating Programming Mode
NOTE: If machine does not power up, check that both the Ground Control Station
– Emergency Stop Button, and the Platform Control Console – Emergency Stop
Button, are in the RESET position.
With machine power OFF, press and hold the Brake Release Button (1) on the Ground 1.
Control Station.
While holding the Brake Release Button in, power machine up by turning the Main Power
2.
Selector Switch (2), to either the Ground Control or Platform Control Mode.
Release the Brake Release Button (1) after machine is powered up. The LCD display
3.
should now display five zeros, one with a box around. Continue to next step Entering
Password.
Entering Password
The Brake Release button (1) moves the box from left to right to select which digit to 1.
change.
Platform UP button (2) increases the numerical digit.
2.
Platform DOWN button (3) decreases the numerical digit. 3.
Change all five digits (4) to match password level, then press the Brake Release button 4.
(1) again.