Snorkel SPM20 CE-sn0001+ - Manual (Page 15)

12
Do not drive at high speeds in restricted or close quarters or when driving in reverse. •
Exercise extreme caution at all times to prevent obstacles from striking or interfering with •
operating controls and persons in the platform.
Ensure that operators of other overhead and floor level machines are aware of the aerial
•
work platform’s presence. Disconnect power to overhead cranes.
Warn personnel not to work, stand, or walk under a raised platform. Position barricades on
•
floor as necessary.
1.4 TOWING, LIFTING, AND HAULING
Never allow personnel in platform while towing, lifting, or hauling. •
This machine should not be towed, except in the event of emergency, malfunction, power •
failure, or loading/unloading. Refer to the Emergency Procedures Section of this manual
for emergency towing procedures.
Ensure platform is fully retracted and completely empty of tools prior to towing, lifting or
•
hauling.
Do not assist a stuck or disabled machine by pushing or pulling except by pulling at the
•
chassis tie-down bars.
When lifting machine with a forklift, position forks only at designated areas of the machine.
•
Lift with a forklift of adequate capacity.
Refer to the Machine Operation section of this manual for lifting information.
•
1.5 Plates and Warning Labels
Upon unpacking, check the plates and warning labels. Do not operate the machine on which
the plates or labels are missing or illegible. Contact the dealer immediately.
The following plates are visible on the machine.
● Nameplate and CE mark