Apple IP (AppleShare IP) Gateway - Manual (Page 36)

3 Designate a folder for the Gateway Manager installation.
You can select any folder on any hard disk, or you can create a new folder
using the following procedure:
a. Click the New Folder ( ) button on the right side of the dialog box. The
New Folder dialog box appears:
b. Type the name of the new folder.
c. Click Create.
4 Click the Select “” button at the bottom of the dialog box.
When you click Install, the Gateway Manager will be installed in this folder.
Designating a System Folder for the gateway software
The gateway software, exclusive of the Gateway Manager, must be installed in
a System Folder. It does, not, however, have to be installed in the System
Folder on the active startup disk, although you will have to use the chosen disk
as the active startup disk when you run the gateway. To choose a System
Folder for the gateway software:
1 Holding down the Option key, click System Disk in the Destination Folder section of the
Installer dialog box, shown in the following figure:
28 Chapter 2 / Installation and Setup