Apple IP (AppleShare IP) Gateway - Manual (Page 34)

7 When you see a message reporting that installation was successful, click Restart.
Designating software locations
The Installer automatically installs the Gateway Manager on the current
startup disk in a folder called Apple IP Gateway. The Installer places all other
gateway software in the System Folder of the current startup disk. You can
change these automatic locations using the Destination Folder section of either
the Easy Install or the Custom Install dialog box.
You can install the Gateway Manager in any folder on any hard disk. You can
install the rest of the gateway software in any System Folder on any hard disk.
IMPORTANT If you do install the gateway System Folder software in the
System Folder of any disk that is not the current startup disk, you will need to
make that disk the current startup disk before you can run the gateway.
Designating a location for the Gateway Manager
You can designate a folder for the Gateway Manager using the following
procedure:
1 Click Select Folder in the Destination Folder section of the Installer dialog box, shown in
the following figure.
26 Chapter 2 / Installation and Setup