Apple IP (AppleShare IP) Gateway - Manual (Page 30)

Using Custom Install
Custom Install allows you to pick and choose which files you want for
installation. The following software is the minimum necessary for the gateway
to run successfully:
m the Apple IP Gateway software, including the Gateway Manager and
MacTCP version 2.0.4 or later
m AppleTalk version 58.1.3 or later
You may want to use Custom Install if:
m you have all necessary software drivers
m you don’t want to install any unnecessary drivers
IMPORTANT MacTCP is included with the Apple IP Gateway software under
Custom Install. If you have a later version of MacTCP already installed, the
Installer will automatically use those later files. You do not have to consider
MacTCP in a custom installation. In addition, the Installer will not install
AppleTalk version 58.1.3 over a later version of AppleTalk.
To use Custom Install:
1 Insert the backup copy of the Apple IP Gateway Installer 1 disk into a floppy disk drive
and double-click the Apple IP Gateway icon to open it.
The Installer icon is in the window that appears.
2 Double-click the Installer icon to open the Installer program.
An informational dialog box appears.
22 Chapter 2 / Installation and Setup