Apple QuickTake 200 Camera - Manual (Page 9)

Formatting the storage card
1 Turn on the camera by sliding the power switch (
‰
) (above the LCD screen) in the
direction indicated by the arrow and then releasing it.
2 To format the storage card, turn the mode dial to Erase (
#
) mode.
3 Use the plus (+) and minus (–) buttons (next to the mode dial) to select FORMAT on
the screen.
4 Press the action button (next to the + and – buttons).
OK? appears blinking on your screen.
5 Press the action button again to format the card.
Write-protecting the storage card
To prevent erasing important data from your storage card, place a write-
protect seal over the write-protect circle on the card. You receive 4 seals with
every card you buy. (You cannot reuse seals.)
This seal makes it impossible to record data to or erase data from the card.
To again use the card to record or erase data, remove the seal.
IMPORTANT Write-protection might not function if the seal becomes dirty. Use
a dry, lint-free cloth to wipe the seal clean.
WARNING When you format a card, all the data on the card is removed,
including any protected images.
9 Getting Started With the QuickTake 200 Camera