Apple QuickTake 200 Camera - Manual (Page 11)

Setting the date and time in the camera
You can set the date and time to date-stamp your images. The date and
time are automatically recorded and appear on the LCD screen or the
television monitor.
1 Turn the mode dial to Record-Fine (
!
) mode.
2 Hold down the plus (+) and minus (–) buttons at the same time for 3 or more seconds.
The date appears with the year flashing.
3 Press the + button to change the year.
IMPORTANT If you advance beyond the number that you want to set, continue
pressing the + button. When the highest number is reached, the display
goes back to the lowest number. For example, when you set the month, the
display goes from 12 back to 1.
4 Press the – button to set the year and advance to the month.
The month appears flashing.
IMPORTANT Press the – button only when you want to set your choice. You cannot
use the – button to go backward if you pass the number that you wanted.
5 Repeat steps 3 and 4 to change and set the month, day, and time.
Press the + button to advance the number flashing. Press the – button
to set the flashing number and move to the next setting. The time appears
after you set the day.
IMPORTANT To set AM and PM , you must advance the hours using the + button.
11 Getting Started With the QuickTake 200 Camera