Apple QuickTake 200 Camera - Manual (Page 6)

Installing the batteries
Before you begin using your camera, you need to install the batteries. Use
the four lithium batteries (AA size) that came with your camera. To obtain
maximum use from your batteries, turn off the camera whenever you are not
using it.
1 Press down on the Push button and slide and open the battery door.
2 Insert the batteries into the camera as shown.
3 Close the battery door by sliding it into place.
See also: Appendix B, “Battery Information.”
Push button
Battery door
WARNING Installing the batteries incorrectly may cause an
explosion. Follow the instructions in this manual to replace the
batteries. Use only the same type of batteries or an equivalent
batteries recommended by the manufacturer of the original
batteries. Do not mix different types of batteries in the camera.
6 Chapter 1
Lithium
(Li)