JB Conversions 2800 LoMax 205 - Manual (Page 9)

LoMax™ 205 – Case and 3:1 Gear Set
JB Conversions, Inc. Page 8
337-625-2379
337-626-8365 fax
www.jbconversions.com
10. Adjust the shim pack (per the measurements taken in step 10) to remove the end play so that the
final setting is 0.000” end play. DO NOT set the shim pack to produce excessive preload on the
tapered roller bearings. Repeat the above procedures to reinstall the intermediate gear.
11. Insert both rail pins into the case (lubricated). Make sure the rail pins can slide easily in the bores.
12. Start the long shift rail into the case from the front with the detent notches facing upward.
Position the fork in the case so that the rail can pass through it. Notice the fork is positioned with
the offset facing inward (see photo in step 15 for view). Push the rail to the neutral (center detent)
position.
13. Install the input bearing into the front of the case.