JB Conversions 2800 LoMax 205 - Manual (Page 2)

LoMax™ 205 – Case and 3:1 Gear Set
JB Conversions, Inc. Page 1
337-625-2379
337-626-8365 fax
www.jbconversions.com
Instructions:
1. Drain the transfer case and remove the shift rail linkage plate.
2. Remove the locknut retaining the front output flange followed by the flange itself.
3. Remove the rear tail cone. Remove the bolts holding the rear bearing retainer to the main case. Do
not remove the snap ring on the rear output shaft located at the bearing.
4. Pull the rear output shaft and rear retainer out of the main case. The slider ring can be pulled out
the case at this point. The shift fork will remain in the case for now.
5. Remove the snap ring from the input shaft. Push or tap the input shaft in toward the case. Remove
it completely after it has passed through the front bearing. Remove the bearing by tapping it
outward from within the case.