JB Conversions 2800 LoMax 205 - Manual (Page 15)

LoMax™ 205 – Case and 3:1 Gear Set
JB Conversions, Inc. Page 14
337-625-2379
337-626-8365 fax
www.jbconversions.com
25. Install the thrust plate onto the shaft followed by the snap ring.
26. Lubricate the shaft with gear oil and Lower the front output shaft assembly into the case. The
shaft should pass through the slide ring, gear, thrust washer, and bearing installed in steps 18-20.
Apply RTV to the bearing retainer and bolt it to the case (20-40 ft-lb.). Use gaskets if you wish.