JB Conversions 15-1103 Dana 300 User Manual
32 spline front output shaft upgrade, Manufactured by jb conversions, inc, Installation instructions

1
D
Daannaa 330000
32 Spline Front Output Shaft Upgrade
Manufactured by JB CONVERSIONS, INC.
Phone: 337-625-2379
Installation Instructions
Part No. 15-1103
Instruction Rev: 2009.09.26
Kit Components
.
32 spline front output shaft
.
Tapered roller bearing #30207 (cup & cone)
.
Spacer ring
.
CV yoke # 2-4-5341
.
7/8" x 20 Lock nut - Chrysler #4167924
.
Rubber star washer seal - Chrysler #4210973
.
National oil seal #473454
IMPORTANT!
PREASSEMBLY CHECK
After the Dana 300 has been disassembled, refer to the photos A & B below to verify
gear-to-shaft clearances. Place the original Dana gears (separately) onto the front
output shaft as shown. Using a gap gauge, verify clearance between the grinded
gear face and the shoulder on the shaft. Use a straight edge as shown.