JB Conversions 2800 LoMax 205 - Manual (Page 20)

LoMax™ 205 – Case and 3:1 Gear Set
JB Conversions, Inc. Page 19
337-625-2379
337-626-8365 fax
www.jbconversions.com
39. Lower the steel bearing housing onto the output shaft. Install the plastic speedometer gear onto the
shaft.
40. Tap the ball bearing into the steel housing followed by the snap ring.
41. Align the slider ring into the shift fork. The slider ring must fit into the clutch teeth on the back of
the input gear.
42. Install the needle bearings into the rear output shaft. Be sure the spacer and retaining ring are
above the needle bearings. Use grease to hold the needle bearings into place.