JB Conversions 2308 Dana 300 - Manual

1
D Daannaa 330000
32 Spline Rear Output Shaft Upgrade
Manufactured by JB CONVERSIONS, INC.
Phone: 337-625-2379
Installation Instructions
Part No. 2308
Instruction Rev: 2009.09.26
Kit Components
. Aluminum bearing housing
. 32 spline rear output shaft
. Aluminum seal retainer
. National oil seal #473239
. (6) Allen cap screws 5/16" x .75"
. (5) Allen cap screws 3/8" x 1.25"
. CV yoke # 2-4-5341
. 7/8" x 20 Lock nut - Chrysler #4167924
. 7/8" x 20 Shim Setup nut
. Rubber star washer seal - Chrysler #4210973
. Speedometer gear - Chrysler #4338996
. Snap ring - Chrysler #4338997
. Large Spacer ring
. Small Spacer ring
. Needle bearing
. Tapered roller bearing #30207 (cup & cone)
. Tapered roller bearing #26822, #26885 (cup & cone)
. Shim set
. Vent fitting 1/8" NPT x 5/16"
IMPORTANT!
Properly secure the vehicle and remove the Dana 300 from the chassis. Drain the
Dana 300 of all oil. The reassembly portion of these instructions illustrates a Dana
300 cut-a-way model. Various components of this display model are removed for
other purposes. The steps for reassembly coincide with the photos therefore you
should not be concerned that your unit is not in a state of disassembly as seen in the
cut-a-way case.