ARB 5611210 - Manual (Page 17)

08-10-09 Page 17 of 19 3783146
53. Fit reflector to end of buffer.
54. Fit urethane buffer to top of end surround
using M6 nyloc nuts and large black flat
washers.
When fitting washers to studs under end
surround smear flat washers with grease to
hold them in place as shown below.
FITTING TOP INFILL PLATE AND ALUMINIUM STEP PLATE
55. Using M6 button head cap screws fit top
infill plate.
56. To fit rubber sealing strip to underside of
aluminium step plate, lay strip on the
underside of step plate and place so over
hang is even on both ends. Using scissors,
cut darts up to the bulb end of the rubber
strip, so the strip can follow the front profile
of the aluminium step plate.
Reflector