Fitting bull bar to vehicle – ARB 3462040 User Manual
Page 15

Last Rev Date: 24/7/07
Page 14 of 16
Fitting instructions# 3783176
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING BULL BAR TO VEHICLE
39. Using two people, three if winch fitted,
position the bar assembly on the vehicle
mounts.
40. Bolt the bar to the mounts using M12
bolts, large flat washers and spring
washers. Align the bar to the profile of the
guards, grille and light profile and tighten
all bolts.
41. Using the M10 pilot holes in mount
brackets, drill pinning hole through
uprights on bull bar. Fit M10 screw,
washer set and flange nut and do up
tight.
42. Trim excess plastic inner guard molding
to meet lower profile of bull bar wing.
Note the position of water bottle on LHS
of vehicle and trim neatly around it.
43. Fit washer bottle protection frame lower
mount to where original bumper stabiliser
arms were located using 2 x M10 x 30
bolt and washer sets. Fit off the other
end to inner wing area of bull bar as
shown using M8 x 25 bolts and washer
sets.
NOTE: The 2 x M8 cage nuts should be in
place from step 38.
Inner bar fixing point
Chassis fixing point
Warning: Drilling operations can result
in flying metal debris, safety glasses
should be worn.