OR-Fab 86201 JEEP TJ SWING AWAY SPARE TIRE CARRIER - NON CANISTER - Manual (Page 11)

NOTE
In the step below, the third light has not been installed.
Check your local laws and or the accessories list at the
back of the instructions if you would like to install a
third light on your vehicle.
Swing-Away Tire Carrier & Tire/Can Carrier 11 Kits 85095, -201, 86095, -201
d. Install cover on open tailgate with screw.
3. Tire mounting.
WARNING
The load rating for these tire-can/tire carriers is a
MAXIMUM of 200lbs. Please be aware that some tire
and wheel combinations along with gas cans and hi-lift
jacks can exceed this MAXIMUM rating.
a. Install kit lock bar on kit tire carrier with two kit
bolts (5/16” x 1”) and two kit flange nuts (5/16”).
b. Position and install tire and wheel assembly on
kit tire carrier with kit urethane spacer, kit alu-
minum plate, and kit T-bar.
4. Kit bump-stop.
CAUTION
In the step below you may need to slightly grind the
face of the kit lower bump-stop so that it will not dent
the tailgate. When adjusted properly the kit lower
bump-stop should just touch the tailgate and the kit 2”
x 2” stainless stick pad.
a. Install the kit lower bump-stop on the kit tire
carrier.
b. Use the location of the kit lower bump-stop on
the tire carrier to position the kit 2” x 2” stain-
less steel stick pad on the tailgate.
c. Tire-can carrier only: Install your gas cans on
tire-can carrier using the bottom lip of the cans
along with two kit threaded rods (3/8 x 8”), kit L-
brackets and kit wing nuts as shown.
Screw
Cover
Tailgate
Kit Lock Bar
Kit Tire
Carrier
Kit Bolts 5/16” x 1”
Kit Flange Nuts 5/16”
Kit Lower Bump-stop
Kit Tire Carrier
Tailgate
Kit 2” x 2” Stainless
Steel Stick Pad
Kit Threaded Rods 3/8 x 8”,
Kit L-brackets, Kit Wing Nuts 3/8”
Gas Cans