OR-Fab 83245 JEEP CHEROKEE XJ HD COMP CUT REAR BUMPER (CUT & FOLDED) REAR LOWER QUARTERS - Manual (Page 3)

3 XJ HD Rear “COMP CUT” Bumper - Kit 83245
2. Install Rear Bumper Bracket and Anchore Strap.
a. Install eight factory bolts into supplied kit
brackets and frame mounts.
b. Place two kit spacers (1/2”) on to kit bumper
mounting bracket.
c. Install kit nut plate(Two 1/2” nuts weld on a
plate) into frame rail through access hole in
frame. Using supplied kit hardware, two 1/2”
bolts & washers, to install anchore strap on
driver’s & passenger’s side frame mounts.
(Note: 7/16” nuts facing up.)
Rear bumper brackets
Bumper
Bracket
Spacers
Nut Plate
d. DO NOT TIGHTEN at this time. (Note: Each
vehicle may very due to added accessories. 91’
& older models will requier you to mark &
drill 1/2” holes to tie in the anchore straps to
the frame). Repeat to passanger side.
Rear Bumper Assembly
1. Install kit bumper on vehicle.
a. Place rear bumper up to mounts, align mounting
holes and use four kit (7/16 x 1 1/4” bolt,
washer, & flange nut) mounting hardware to
secure top of kit bumper to kit mounting
brackets.
Install nut plate through frame rail Mounting Flange
Anchore Strap mounts to
factory frame rail mount
Anchore Strap mounted
to bumper bracket
Spacers
Bumper
Spacers
Bumper
1/2” Hardware
1/2” Hardware