OR-Fab 83240 JEEP CHEROKEE XJ FRONT HD BUMPER WITH HOOP - Manual (Page 4)

4 ‘84-’01 XJ Front Bumper - Kit 83240, 83241
4. Remove three steering box bolts and washers from
driver side unibody and steering box.
Install Kit
Engine Compartment
1. Cruise Control Models: Vacuum lines
Bolts &
Washers
Unibody
Steering
Box
Check Valve
T-Connector
Vacuum Reservoir
AFTER
BEFORE
Intake Manifold
Cruise Control
Manifold Line
Fitting
Reservoir
Line
*Not To Scale
a. Remove line from cruise control fitting and t-con-
nector.
b. Remove T-connector from reservoir line and
manifold line.
c. Trim manifold line, if necessary, and install onto
cruise control fitting.
d. Remove wiring harness and clips from driver
side inner fender.
e. Install two kit bracket (2” step) onto driver side
inner fender with two kit bolts (5/16” x 3/4” self-
tapping). DO NOT TIGHTEN.
WARNING
Vacuum fittings and lines may have become brittle over
time. Use care when handling fittings and vacuum
lines. If necessary, use lengths of kit line (vacuum) in
place of cracked or damaged vacuum line.
Inner
Fender
Clips
Wiring
Harness
Vacuum
Reservoir
Kit Bracket
(2” Step)
Kit Bolt
(5/16” x 3/4”)