OR-Fab 83224 JEEP JK WRANGLER / STUBBY FRONT BUMPER WITH HOOP AND OEM LIGHT MOUNTS - Manual (Page 4)

JK Wrangler HD OEM Fog Light Bumper 4 Kit #83204/83212/83224
5. Install kit bumper onto lower crush zone with four kit
nuts (1/2”-13 flange), four kit large washers (1/2”
ID), and four kit bolts (1/2”-13 x 1-1/4” button).
TIGHTEN all kit bumper hardware.
6. Connect fog light wiring harnesses onto fog lights.
Crush Zone
Kit Nut (1/2”-13
flange)
Kit Bolts (1/2”-13 x 1-1/4” Button) Kit Bumper
Kit Large
Washer (1/2”)
Wiring Harness Fog Light
After Completing Installation
Engine Compartment
1. Connect both battery cables. Connect positive cable
first, then negative cable.
Miscellaneous
1. Check all fasteners to ensure they are tight.
2. Ensure all wires, hoses, cables, etc. are properly
connected and there is ample slack.
Dynamic Vehicle Check
1. Check steering in both directions to ensure that
there is no bind. Check operation of clutch, brake
system, and parking brake. Check operation of
transmission and transfer case. Ensure there is full
engagement in all gears and 4WD ranges. Check
battery connections and electrical component oper-
ations. Test-drive vehicle.
2. Check steering and suspension in all positions to
ensure that there is no bind and adequate clearance
between all moving, fixed, and heated members.
Check tire-to-bumper clearance and ensure no con-
tact in any position. Test-drive vehicle.
WARNING
Retorque all fasteners after 500 miles and after off road
use. All body lift components should be visually
inspected and fasteners retorqued during routine vehi-
cle servicing.
CAUTION
Performance Automotive Group does not recommend
any particular wheel and tire combinations for use with
its products and cannot assume responsibility for the
customer’s choice of wheels and tires. Refer to your
owner's manual for recommended tire sizes and warn-
ings related to the use of oversized tires. Larger wheel
and tire combinations increase stress and wear on
steering and suspension components, which leads to
increased maintenance and higher risk for component
failure. Larger wheel and tire combinations also alter
speedometer calibration, braking effectiveness, center
of gravity, and handling characteristics. Consult an
experienced local off road shop to find what wheel and
tire combinations work best with your vehicle.
Copyright 08/10
Performance Automotive Group
www.p-a-g.net