OR-Fab 83224 JEEP JK WRANGLER / STUBBY FRONT BUMPER WITH HOOP AND OEM LIGHT MOUNTS - Manual (Page 3)

JK Wrangler HD OEM Fog Light Bumper 3 Kit #83204/83212/83224
a. Install kit OE light bracket to mount OE lights
onto kit bumper installing OE lights at the same
time with eight kit bolts (1/4”-20 x 1”), eight kit
washers (1/4” SAE) and eight kit nuts (1/4”-20
Nylock)..
2. Place kit “D-ring” bracket into kit bumper slots.
Kit Bumper Fog Lights
Kit Bolts (1/4”-20 x 1”), Kit Washers (1/4” SAE),
Kit Nuts (1/4”-20 Nylock)
Kit D-Ring Bracket
3. Install kit bumper onto frame horns with eight kit
bolts (1/2”-13 x 1-1/4” button) and eight kit nuts (1/
2”-13 Flange). DO NOT TIGHTEN.
4. Note: 2010 & 2011 Models mark and drill
passenger side lower crash bar. Mark and drill
(using a 1/2” drill bit) passenger side lower crash bar
so kit Bolts (1/2-13x1 1/4 botton head) may sit flush
through bumper..
Kit Bumper Kit Bolts (1/2”-13 x 1-1/4” Button)
Kit Nuts (1/2”-13 Flange)
OUTSIDE
INSIDE
Drill 1/2” hole on
Passenger side
crash bar.