Fluid Management Miller GyroMixer - Manual (Page 24)

SERVICE
20
SERVICE GENERAL INFORMATION
If you do not feel confident about disassembling the paint mixer or replacing a part,
DO NOT ATTEMPT THE PROCEDURE. Should problems or questions arise,
contact Customer Service at Fluid Management.
Carefully read all of the instructions before you begin. For component
identification and location, refer to the Parts Section of this manual.
WARNING ELECTRICAL HAZARD
Always shut off the POWER switch and unplug
the mixer before servicing.
CAUTION Wear safety glasses to prevent possible injury.
Recommended Spare Parts
Belts: Primary: 16-rub poly-V belt Part Number 18444
Secondary: V-belt, Part Number 18396
Bail Retainer Part Number 20810
Rubber Pad Part Number 18351
Special Tools
Belt tensioning gauge
Voltage meter