Fluid Management Miller GyroMixer - Manual (Page 18)

OPERATIONS
14
8. Move the POWER lever to the ON position.
WARNING A safety interlock system prevents the operator
from opening the sliding door while the mixer is
running. Do not attempt to open the door while
the mixer is running.
• For an emergency stop in mid-cycle, push the EMERGENCY STOP
button.
• If vibrations occur, turn off the machine and refer to the leveling
section of this manual.
9. When the mixer has completed its cycle, move the power lever to the
OFF position.
10. Open the sliding door.
11. Rotate the mechanism to an upright locking position.
12. Use the knob marked "open" to turn the crank handle in the direction of
the arrow until the container is free. If necessary rotate the bail shield
away from the bail and remove the container.
MIX TIMES
Material Quantities Approx. Mix Times *
Latex Paint 5 gal, 15L, 20L 15 - 30 seconds
Latex Paint 1 gal, 5L or less 30 - 60 seconds
Gum-Based Paint 20L 1 - 1.5 minutes
Stucco** 5 gal, 15L, 20L 1.5 - 2 minutes
* Actual mixing times may vary depending upon material viscosity, container
size, head space, and colorant.
** When mixing stucco or other textured coatings, tip the container upside-
down, then upright again before adding colorant.