Hale RSD - Manual (Page 67)

67 Section 6: Corrective Maintenance
Hale Products, Inc., Nov.2005, Rev.-A
Co rr ec tive M ain te n an ce
❑
6 Repair
6.1 OVERVIEW
This section describes the removal, inspection, and reinstallation (as
required for maintenance and repair) of the Hale pump and gearbox compo-
nents. To completely dismantle the pump and gearbox, follow the disas-
sembly instructions in the order which they appear in this section. At any
point in the disassembly process, the unit can be reassembled by following
the instructions in the reverse.
Service should be performed by a trained and qualified service technician,
or your authorized Hale Products service representative. Be sure you have
sufficient knowledge, experience and the proper tools.
Wherever there is a requirement for new parts, it is recommended to use
only Hale authorized replacement parts for optimum safety of the equip-
ment and its operators and to limit “downtime.”
6.2 GENERAL REPAIR GUIDELINES
Before You Begin...
For a parts breakdown and identification, see Section 8, heading “Drawing
Package” on page 127.
READ ALL INSTRUCTIONS THOROUGHLY
BEFORE BEGINNING ANY SERVICE REPAIR.
1. Place apparatus out of service in accordance with your departmental
procedures.
2. Park the vehicle on a level surface. Set the parking brake and chock the
front and rear wheels.
3. Match mark, tag and/or note, or photograph the orientation of all
mechanical and electrical components and connections to the pump
and/or gearbox before disconnecting or removing them. This aids in
proper reassembly.
4. Determine best method for servicing, i.e., servicing while in the appara-
tus or removal from the top or bottom of the apparatus.