Hale RSD - Manual (Page 103)

103 Basic Installation
Hale Series Pumps, Nov.-05, Rev-A
In sta llatio n
❑
7 Installation
7.1 OVERVIEW
This section provides general guidelines and recommendations for installing
the pump and gearbox assembly into your truck chassis.
7.2 FRAME MOUNTING
See Section 8, heading “Drawing Package” on page 127, located at the
back of this manual, for the required mounting specifications. The installa-
tion drawing provides mounting configurations with bolt down specifications.
IMPORTANT!
TO FULLY SUPPORT THE PUMP AND GEARBOX ASSEMBLY, USE ALL
MOUNTING BOLT HOLES PROVIDED IN THE GEARBOX, AS ILLUSTRATED
ON THE INSTALLATION DRAWING. SEE SECTION 8, HEADING “DRAWING
PACKAGE” ON PAGE 127.
WARNINGS !
THE HALE PUMP AND GEARBOX ASSEMBLY ARE HEAVY AND BULKY.
ADDING ACCESSORIES INCREASES THE WEIGHT. CHECK YOUR BILL OF
LADING FOR THE APPROXIMATE WEIGHT. BE CERTAIN TO USE PROPER
LIFTING SUPPORT DEVICES (I.E., OVERHEAD CRANE, JACK, CHAINS,
STRAPS, ETC.) CAPABLE OF HANDLING THE LOAD WHEN REMOVING OR
INSTALLING THE PUMP AND GEARBOX ASSEMBLIES.
BE SURE TO WEAR SAFETY GLASSES WHEN REMOVING AND/OR INSTALL-
ING FORCE (PRESS) FITTED PARTS. FAILURE TO COMPLY MAY RESULT IN
SERIOUS EYE INJURY.
General Mounting
Tapped holes of various sizes and depths are provided, dependent on pump
model and layout requirements.
Mounting also varies depending on assembly configuration, i.e.,
❑ Horizontal