Brother MFC 7050C - Manual (Page 58)

I N I T I A L S E T U P
5-6
Setting Volume Amplify
Please carefully read “Choosing the Handset Volume,” page 5-5
before you do the following steps:
1 Press Function , 1 , 1 , 6 .
VOL AMPLIFY:OFF?
SELECT <- -> & SET
2 Press or to select VOL AMPLIFY:OFF? if none of
the users are hearing-impaired and go to Step 4—OR—
if some or all of the users are hearing-impaired, select
VOL AMPLIFY:ON?.
PERMANENT?
SELECT <- -> & SET
3 Press or to select PERMANENT? if all the users are
hearing-impaired—OR—select TEMPORARY? if only some
of the users are hearing-impaired.
4 Press Set .
5 Press Stop to exit.
Setting the Speaker Volume
You can adjust the volume of the one-way speaker when your
MFC is on
Hook . You can turn the speaker off or you can select a
speaker volume level. The default setting is the lowest volume.
■ Press L or H to adjust the volume level. The display
shows the setting you are choosing. Each key press changes
the volume to the next setting. The new setting will remain
until you change it again.
You can adjust the speaker volume while you are listening to your
OGM (Outgoing Message) and ICMs (incoming messages).
If you turn the Incoming Recording Monitor to OFF
(
Function , 1 , 7 , 5 ), the Speaker for screening calls will be
disabled and you will not be able to hear callers leaving messages.
The volume for other operations can still be controlled using
L
and H .