Time and items required, Removing a cable management finger assembly – Brocade Communications Systems Brocade VDX 8770-4 User Manual
Page 68
48
Brocade VDX 8770-4 Hardware Reference Manual
53-1002563-02
Cable management finger assembly removal and replacement
5
•
Wear a wrist grounding strap connected to chassis ground (if the Brocade VDX 8770-4 is
plugged in) or a bench ground. Refer to
“Port side of the Brocade VDX 8770-4 (sample
on page 3 for the location of the ESD jack.
•
Store ESD-sensitive components in antistatic packaging.
Cable management finger assembly removal and replacement
The Brocade VDX 8770-4 comes equipped with two vertical cable management finger assemblies.
It can continue to operate during the replacement of the cable management fingers. Due to the
horizontal orientation of the line cards in the Brocade VDX 8770-4, the cable management finger
assemblies are attached to the uprights of the mounting rack. Refer to
for this
procedure.
Time and items required
The replacement procedure for the cable management finger assembly takes less than five
minutes. A #1 Phillips screwdriver is required.
Removing a cable management finger assembly
Complete the following steps to remove the cable management finger assembly. Refer to
for the location of the assembly.
1. Remove the cables from the cable management finger assembly and rearrange the cables
around the it.
2. Unscrew and save the three screws holding the cable management finger assembly to the rack
upright. Support the assembly to prevent it from falling.
3. Remove the cable management finger assembly.
4. If necessary, repeat step 1 through step 3 for the other cable management finger assembly.