Brocade Communications Systems Brocade VDX 8770-4 - Manual (Page 41)

Brocade VDX 8770-4 Hardware Reference Manual 21
53-1002563-02
Establishing a serial connection to the Brocade VDX 8770-4
3
If the serial port on the workstation or terminal device is DB9 instead of RJ-45, remove the
adapter on the end of the serial cable and insert the exposed DB9 connector into the DB9
serial port on the workstation.
ATTENTION
The serial port is intended primarily for the initial setting of the IP address and for service
purposes.
4. Disable any serial communication programs running on the workstation (such as
synchronization programs).
5. Open a terminal emulator application (such as HyperTerminal on a PC, or TERM, TIP, or Kermit
in a UNIX environment), and configure the application as follows:
• In a Windows environment, use the following parameters:
• In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
If ttyb is already in use, use ttya instead and enter the following string at the prompt:
tip /dev/ttya -9600
Table 7 lists the serial cable pinouts.
TABLE 6 Windows serial connection parameters
Parameter Value
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None
TABLE 7 Serial cable pinouts
PIN Signal Description
1 Not supported NA
2 Not supported NA
3 TXD Transmit data
4 GND Logic ground
5 Not supported NA
6 RXD Receive data
7 Not supported NA
8 Not supported NA