Brother FAX-1030E - Manual (Page 21)

Setup
14
B
ASIC USE
Custom Settings
Volume Settings
Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The machine comes set to LOW. When the beeper
is set to LOW or HIGH, the machine beeps every time you press a key or make an error, and at the
end of sending or receiving a fax.
1
Press Menu/Set, 1, 4.
2
Press or to select your setting.
3
When the screen displays the setting you want, press Menu/Set.
4
Press Stop/Exit.
Speaker Volume
You can adjust the speaker volume. If you have FAX-1020e, you must lift the handset, then press
Hook before you can adjust the volume. If you have FAX-1030e, press Speaker phone.
Press or to adjust the volume level. The display shows the setting you are choosing. Each
key press changes the volume to the next setting. The new setting will remain until you change it
again.
Ring Volume
You can adjust the ring volume when your fax machine is idle. You can select a ring volume level
or press
or until the ring is off.
Press or to adjust the volume level. With each key press, the fax machine rings so you can
hear the current setting and the display shows the setting you are choosing. Each key press changes
the volume to the next setting. The new setting will remain until you change it again.
Setting the Music on Hold
You can set the machine to play or not to play the music during the machine is holding a voice call.
1
Press Menu/Set, 1, 5.
2
Press or to select ON (or OFF), and press Menu/Set when the screen displays your
selection.
3
Press Stop/Exit.
If you have FAX-1030e, you can adjust the speaker volume while you are listening
to your OGM (Outgoing Message) and ICMs (incoming messages).
If you turn Incoming Recording Monitor to OFF (Menu/Set, 8, 5) on FAX-1030e,
the Speaker for screening calls will be disabled and you won’t hear callers leaving
messages. The volume for other operations can still be controlled using
and
.