12 - 3 troubleshooting and routine maintenance – Brother MFC-8440 B User Manual
Page 164
12 - 3 TROUBLESHOOTING AND ROUTINE MAINTENANCE
Out Of Memory
You can’t store data in the memory.
(Fax sending in process)
Press Stop and wait until the other
operations in progress finish and
then try again.
—OR—
Clear the data in the memory.
(See Out of Memory message on
page 10-5.)
(Copy operation in process)
Press Stop and wait until the other
operations in process finish and
then try again.
—OR—
Clear the data in the memory.
(See Out of Memory message on
page 10-5.)
—OR—
Add an optional memory.
(See Memory board on page 13-1.)
(Printing operation in process)
Reduce print resolution. (See Print
Quality in Software User’s Guide on
the CD-ROM.)
—OR—
Clear the data in the memory.
(See Out of Memory message on
page 10-5.)
—OR—
Add an optional memory.
(See Memory board on page 13-1.)
No
Response/Busy
The number you dialed does not answer or is
busy.
Verify the number and try again.
Not
Registered
You tried to access a One-Touch or
Speed-Dial number that is not programmed.
Set up the One-Touch or Speed-Dial
number. (See Storing One-Touch
Dial numbers on page 7-1 and
Storing Speed-Dial numbers on
page 7-2.)
Pls Open
Cover
A page, piece of paper or paper clip, etc. may
be jammed inside the MFC.
Open the front cover. If you see any
jammed paper or other item, gently
pull it out, then close the front cover.
If the error message remains, open
and close the front cover again.
If the MFC cannot reset itself and
return to the date and time prompt, it
will display Machine Error XX.
Please call Brother Customer
Service and tell them the Machine
Error number:
In USA:
1-800-284-4329
In Canada:
1-877-BROTHER
No DX Tray
You tried to make duplex printing with duplex
cover open.
Install the duplex tray correctly.
(See Paper is jammed in the duplex
tray (For MFC-8640D, MFC-8840D
and MFC-8840DN) on page 12-11.)
ERROR MESSAGES
ERROR
MESSAGE
CAUSE
ACTION