Brother MFC-8440 B - Manual (Page 156)

11 - 3 IMPORTANT INFORMATION
WARNING
This MFC has been certified to comply with FCC standards, which
are applied to the USA only. A grounded plug should be plugged into
a grounded AC outlet after checking the rating of the local power
supply for the MFC to operate properly and safely.
Federal Communications Commission (FCC)
Declaration of Conformity (USA only)
declares, that the products
Product Name: MFC-8440, MFC-8640D, MFC-8840D and
MFC-8840DN
comply with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Responsible Party: Brother International Corporation
100 Somerset Corporate Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700