Toshiba Qosmio G40 - Manual (Page 71)

User’s Manual 4-5
Qosmio G40
Points to note about the Fingerprint Sensor
Please be aware of the following considerations when using the fingerprint
sensor. A failure to follow these guidelines might result in damage to the
sensor, sensor failure, fingerprint recognition problems or a lower
fingerprint recognition success rate.
■
Do not scratch or poke the sensor with your nails or any hard or sharp
objects.
■
Do not press the sensor strongly.
■
Do not touch the sensor with a wet finger or any wet objects - keep the
sensor surface dry and free from water vapor.
■
Do not touch the sensor with a soiled or dirty finger as minute foreign
particles of dust and dirt may scratch it.
■
Do not paste stickers or write on the sensor.
■
Do not touch the sensor with a finger or any other object which may
have a build-up of up static electricity on it.
Observe the following before you place your finger on the sensor whether
for fingerprint enrollment/registration or recognition.
■
Wash and dry your hands thoroughly.
■
Remove static electricity from your fingers by touching any metal
surface. Static electricity is a common cause of sensor failures,
especially when the weather is dry.
■
Clean the sensor with a lint-free cloth - do not use detergent or any
other chemicals to clean the sensor.
■
Avoid the following finger conditions for enrollment or recognition as
they may result in fingerprint enrollment errors or a drop in the
fingerprint recognition success rate
■
Soaked or swollen finger, for example as may occur after
taking a bath.
■
Injured finger
■
Wet finger
■
Soiled or oily finger
■
Extremely dry skin condition on finger
Observe the following to improve the fingerprint recognition success rate.
■
Enroll two or more fingers.
■
Enroll additional fingers if a recognition failure often occurs when using
already enrolled fingers.
■
Check the condition of your finger - any conditions which have changed
since enrollment, such as injury, rough skin, and extremely dry, wet,
soiled, dirty, oily, soaked or swollen fingers, may lower the recognition
success rate. Also if the fingerprint is worn down or the finger becomes
thinner or fatter, the recognition success rate may be lowered.
■
As the fingerprint for each finger is different and unique you should
ensure that only the registered or enrolled fingerprint or fingerprints are
used for identification.