Connecting the modular cable – Toshiba Qosmio G40 User Manual
Page 101
User’s Manual
4-35
Qosmio G40
Connecting the modular cable
To connect the modem’s modular cable, follow the steps as detailed below:
1. Plug the end of the modular cable into the computer’s modem jack.
2. Plug the other end of the modular cable into a telephone jack.
Connecting the internal modem
■
Connection to any communication line other than an analog phone line
could cause a computer system failure.
■
Connect the built-in modem only to ordinary analog phone lines.
■
Never connect the built-in modem to a digital line (ISDN).
■
Never connect the built-in modem to the digital connector on a
public telephone or to a digital private branch exchange (PBX).
■
Never connect the built-in modem to a key telephone system for
residences or offices.
■
Never operate your computer on AC power during a thunderstorm.
If you see lightning or hear thunder, immediately turn off the computer.
An electric surge caused by the storm, may result in a system failure,
loss of data or hardware damage.
Modem jack
Telephone jack
Do not pull on the cable or move the computer while the cable is
connected.
If you use a storage device such as an optical drive or hard disk drive
connected to a 16-bit PC Card, you might experience the following
problems with the operation of the modem:
■
The modem speed is slow or communication is periodically interrupted.
■
Skips or jumps may be noted in sound.