beautypg.com

External monitor – Toshiba Qosmio G40 User Manual

Page 207

background image

User’s Manual

10-21

Qosmio G40

External monitor

Please also refer to Chapter 9,

Optional Devices

, and to the documentation

supplied with your monitor for further information.

Problem

Procedure

Monitor does not
turn on

After confirming that the monitor’s power switch
is on, you should check the connections to make
sure that the power cord/adaptor is firmly
connected to the monitor and to a working power
outlet.

No display

Try adjusting the contrast and brightness controls
on the external monitor.

Press the FN + F5 hot key in order to change the
display priority and ensure that it is not set for the
internal display panel only.

Check to see if the external monitor is connected.

When the external monitor is set as the primary
display device in extended desktop mode, it will
not display when the computer wakes up from
Sleep Mode if the external monitor has been
disconnected while in Sleep Mode.

To keep this from happening, do not disconnect
the external monitor while the computer is in
Sleep or Hibernation Mode.

Remember to turn off the computer before
disconnecting the external monitor.

When the display panel and an external monitor
are set to clone mode and the monitors are
turned off by the timer, the display panel or the
external monitor may not display when turned on
again.

If this occurs, press FN + F5 to re-set the display
panel and external monitor to clone mode.

Display error occurs

Check that the cable connecting the external
monitor to the computer is firmly attached.

If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.