Toshiba Magnia Z500 - Manual (Page 94)

Appendix 1 SNMP Settings
When you set up the Software Access Point from the remote PC, using the Access Point Configuration Utility,
the SNMP Extension Agent must be active on the server (access point).
The following explains the settings for SNMP for Windows NT, Windows 2000, and Linux, respectively
[For Windows NT]
For information on installing the SNMP Extension Agent, see the following section.
[2.1.1.1 For installation in Windows NT]
The following describes the settings to be made after the SNMP Extension Agent is installed.
1. Click the [Network] icon on the Control Panel on the server (access point).
2. Select the [Service] tab and open the property of [SNMP service].
3. When the [Security] tab is selected, the following page is displayed.
4. Add the community name of the [READ WRITE] authority to [Accepted Community Names].
(In the above example, "tsap" is added.)
This community name is used to connect the Access Point Configuration Utility to the server (access
point).