Toshiba Magnia Z500 - Manual (Page 71)

3.5.4 Wired LAN selection page
This page is for the settings that correspond to Windows-version "Wired LAN Selection Utility."
To display the wired LAN selection page, access the following URL while the MAGNIA Software
Access Point is active.
http://(server IP address)/tsb/tsb_bridge.cgi
Memo
As explained above, you need to undergo user authentication before accessing this page.
Memo
The setup page that can be accessed by the above URL operates, assuming that the WEB server
(apache), attached as a standard feature, is operating without any setting change. If the WEB
server's settings have been changed, an access failure or abnormal operation may occur. For
the WEB server settings, consult with your server administrator.
‹ Wired LAN selection page
Item Explanation
Selection check box Displays optional wired LAN devices.
Select the wired LAN device you want to connect.
[Apply] button Ends up saving the selected item.
[Reset] button Ends up without saving the selected item.
‹Notice‹
The wired LAN selection page is used to update the setup page but not to change the settings
during operation. This is because when a change is reflected, the network shuts down
temporarily, so that the change may not correctly be reflected. To reflect the change, log in by
root and manually execute the following command.
# /etc/rc.d/init.d/tsb_bridge restart
You can achieve similar effects by restarting the active Operating System with the
following command. However, the system is significantly affected or another service
stops over a relatively long period of time; therefore, use the above method as much as
possible.
# reboot