Toshiba Magnia Z500 User Manual
Page 29
In the case of upgrade, execute the following command. Here, the example of
upgrading 2.0-0, installed in Step 4, to 2.1-0 is given.
for Red Hat 7.2
for Turbolinux 7
Step 5 To operate the Linux-version MAGNIA Software Access Point, execute the following
command.
Notice
When Step 5 is executed, the service of the network including the wireless LAN may
become abnormal. Before executing this step, well check the operation status of
another network service. To execute Step 5, consult with the server administrator.
You can achieve similar effects by restarting the active OS with the following command.
However, another service stops over a relatively long period of time; therefore, use the
above method as much as possible.
# reboot
# rpm -U tsap-2.4.9-3-1.1-0.i586.rpm
# rpm -U tsap-2.4.7-10-2.1-0.i386.rpm
# /etc/rc.d/init.d/httpd restart
# /etc/rc.d/init.d/pcmcia restart
Step 6 Set up the required items in the Access point setup page. By the default, WEP and
MAC address filtering are enabled.
Step 7 Select the wired LAN network that you want to connect to in the Wired LAN selection
page.
3.5.4 Wired LAN selection page
Notice
The free area of a minimum of 1 MBytes is required for HDD to installation.
/var/tmp is used as a working area at the time of installation. If this directory is not exist, or when
the free area is not enough, it may be unable to install normally.
In order to communicate with an Access Point Configuration Utility(the Windows version), it is
necessary to install beforehand the SNMP package in the distribution.
For details on setup procedure of SNMP, see the following section.
[Appendix 1 SNMP Settings]
Depending on a security configuration at the time of installation of Linux, a setup from a WEB
browser or a setup from SNMP may not be able to be performed. In this case, the change of
security configuration is required. Please read the manual of each Linux distribution about security
configuration.