Toshiba Magnia Z500 - Manual (Page 90)

4.3.2.2 Access point
The following is the setting procedure for the access point.
Step 1 Setting the 802.1X function at the access point
Make settings for the 802.1X function.
The following procedure is to enable the 802.1X function. The other settings of the [Basic setting]
and [Access restriction] tabs are omitted.
1. Start the access point setting utility.
2. Select the [WEP] tab.
3. 802.1X group
Select [Make 802.1X authentication (permit non-802.1X station to coexist] in the
[802.1X] component box.
Place a check mark in the [Distribute WEB key] check box.
Place a check mark in the [Reauthenticate during WEP key distribution] check box.
Set 600 in the [WEP key change interval] edit box.
Select the [Key length] radio button of [13 byte].
4. WEP group
Set a 13-bytes WEP key in [key 1].