Toshiba Magnia Z500 - Manual (Page 70)

3.5.3.3 [Advanced] setup page
Jump to the [Advanced] setup page shown below by the “Advanced” link on the left pane.
Memo
As explained above, you need to undergo the user authentication before accessing this page.
‹Notice‹
The setup items of the details setup page are not required for the usual operation. To change the
setup items of the details setup page, you need a detailed knowledge about the network;
therefore, do no change them unless required.
‹ [Details setup] page
Item Explanation
[Multicast rate] Specifies the transmission rate of multicast packets sent from
the access point.
Select 1, 2, 5.5, or 11 Mbps.
The default is 2 Mbps.
[Distance between
Access Points]
Specifies the size of the area covered by access points.
Select “Large,” “Medium,” or “Small.”
The default is “Large.”
[DTIM Period] DTIM is an acronym of Delivery Traffic Indication Map. The
send timing of multicast packets sent from the access point can
be adjusted.
When the value is 1 (normal), a multicast packet is sent at every
beacon. When the value is 3, multicast packets are
accumulated in the buffer and sent every third beacon.
Although a value from 1 to 65535 can be specified, it is
recommended to set 1 for normal operation.
The default is 1.
[Apply] button Ends up saving the selected item.
[Reset] button Ends up without saving the selected item.