Toshiba Qosmio G10 - Manual (Page 94)

User’s Manual 4-17
Operating Basics
Installing InterVideo WinDVD Creator
To install the InterVideo WinDVD Creator, you must logon with
administrator rights.Before you install InterVideo WinDVD Creator, close all
programs.
1. Insert the Additional Software CD-ROM that contains WinDVD Creator
Software into your optical disk drive.
2. Follow the installation instructions that appear on the screen.
3. When the installation is complete, restart your computer when
prompted for the changes to take effect.
When WinDVD Creator Platinum is used
You can record video back to your digital camcorder via i.LINK (IEEE1394)
using WinDVD Creator Platinum. However, there is a case where its
playback sound is choppy. This can be rectified by performing the following
steps:
1. Click the start and select the Control Panel.
2. Click the Performance and Maintenance icon in the Control Panel.
3. Click the System icon in the Performance and Maintenance window.
4. Click the Advanced tab in the System Properties window.
5. Click the Settings icon in the "Performance" section.
6. Click the Advanced tab in the Performance Options window.
7. Click the Change icon in the "virtual memory" section.
8. Select the Custom size button in the Virtual Memory window.
9. Specify much higher values for "Initial size" and "Maximum size."
10. Click the Set button in the Virtual Memory window.
11. Click the OK button in the Virtual Memory window.
How to make a DVD-Video
Simplified steps for making a DVD-Video from video data captured from a
DV-Camcorder:
1. Click [Start]-[All Programs] - [InterVideo WinDVD Creator2] - [InterVideo
WinDVD Creator] to launch WinDVD Creator.
2. Click [Capture] button then capture the video data from the DV-
Camcorder via IEEE1394.
3. Click [Edit] button then drag the video clips from [Video Library] tab to
the edit track.
4. Click [Make Movie] button in the top bar.
5. Double Click the Right arrow button icon in the centre of right side.
6. Put a blank DVD-R/+R disc or an erased DVD-RW/+RW disc in the
drive.
7. Click [Start] to record to the disc.
8. When recording is finished, the tray opens.