Toshiba Qosmio G10 - Manual (Page 196)

User’s Manual 10-16
Troubleshooting
LAN
Wireless LAN
If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 4,
Operating Basics .
After making a call you
can’t hear a ring Make sure the tone or pulse selection in your
communications application is set correctly.
You can also use the ATD command.
Communication is cut
off unexpectedly The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.
A CONNECT display is
quickly replaced by NO
CARRIER Check the error control setting in your
communications application.
You can also use the AT\N command.
Character display
becomes garbled
during a
communication In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
You cannot receive an
incoming call Check the rings before auto answer setting in
your communications application.
You can also use the ATS0 command. If
problems persist, contact your dealer.
Problem Procedure
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN does
not work Make sure the AC adaptor is connected. The
Wake-up on LAN function consumes power even
when the system is off.
If problems persist, consult your LAN
administrator.
Problem Procedure
Cannot access
Wireless LAN Make sure the computer’s wireless
communication switch is set to on.
If problems persist, contact your LAN
administrator.