Toshiba Qosmio G10 - Manual (Page 170)

User’s Manual 9-11
Optional Devices
5. Slide your fingernail or a thin object under the cover and lift it off.
Removing the memory module cover
6. Fit the memory module’s connectors into the socket at about a
45 degree angle and push the module down until latches on either side
snap into place.
Seating the memory module
7. Seat the memory module cover and secure it with one screw.
8. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power, for details.
9. Return your computer to the upright position.
10. Turn the computer’s power on and make sure the added memory is
recognized. Open System Properties in the Control Panel and click
the General tab.
Removing memory modules
To remove the memory module, make sure the computer is in boot mode
then:
1. Set the computer to boot mode and turn the computer’s power off.
Make sure the Power indicator is off.
2. Remove AC adaptor and all cables connected to the computer.
Memory module cover
Screw
Slot A
Slot B
■
Be careful not to drop the screw inside the computer.
■ Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.