Toshiba Qosmio G30 HD-DVD (PQG32) - Manual (Page 219)

User’s Manual 10-7
Troubleshooting
Real Time Clock
Password
Battery doesn’t power
the computer as long
as expected If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential - in these instances you should fully
discharge the battery and then attempt to charge
it again.
Check the power consumption settings within the
TOSHIBA Power Saver and consider using a
power saving mode.
Problem Procedure
The following
message is Displayed
on the LCD screen:
RTC battery is
low or CMOS
checksum is
inconsistent.
Press [F1] key to
set Date/Time.
The charge in the Real Time Clock (RTC) battery
has run out - you will need to set the date and
time in the BIOS setup application by using the
following steps:
1. Press the F1 key - the BIOS setup application
will load.
2. Set the date in the System Date field.
3. Set the time in the System Time field.
4. Press the End key - a confirmation message
will be displayed.
5. Press the Y key - the BIOS setup application
will end and the computer will restart.
Problem Procedure
Problem Procedure
Cannot enter
password Please refer to the TOSHIBA Password Utility
section in Chapter 6, Power for further
information.