Toshiba Qosmio G30 HD-DVD (PQG32) - Manual (Page 204)

9-22 User’s Manual
Optional Devices
4. Carefully pull the floppy disk drive’s USB connector out from within the
computer’s USB port.
External monitor
An external analog monitor can be connected to the computer’s external
monitor port, with the computer supporting WXGA+ and WUXGA video
modes. In order to connect a monitor, follow the steps as detailed below:
1. Turn the computer’s power off.
2. Connect the monitor cable to the external monitor port and tighten the
screws on the left and right hand side of the connector as required.
Connecting the monitor cable to the external monitor port
3. Turn the external monitor’s power on.
4. Turn the computer’s power on.
When you turn on the power, the computer will automatically recognize the
monitor and determine whether it is a color or monochrome device. In the
event that you find that there are issues getting an image displayed on the
correct monitor, you should consider using the Fn + F5 hot key to change
the display settings (if you then disconnect the external monitor before you
turn the computer’s power off, be sure to press Fn + F5 hot key again to
switch to the internal display).
Please refer to Chapter 5, The Keyboard , for further details on using hot
keys to change the display setting.
Monitor cable
External monitor port
Screws
The computer is equipped with either an HDMI or D-Video out port.