Toshiba Qosmio G30 HD-DVD (PQG32) - Manual (Page 197)

User’s Manual 9-15
Optional Devices
7. Seat the memory module cover in place and secure it with one screw.
Seating the memory module cover
8. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power , if required.
9. Turn your computer over.
10. Switch the computer on and make sure the added memory is
recognized - this can be confirmed by clicking start followed by Control
Panel followed by Performance and Maintenance and then selecting
the System icon.
11. Open the System Properties window and then click the General tab.
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 3, Getting Started , if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
Align the grooves along the edges of the memory module with the locking
tabs on the connector and insert the module into the connector firmly - if
you find it difficult to install the memory module, gently prise the locking
tabs outwards using the tip of your finger.
Please also ensure that you hold the memory module along its left and
right hand edges - the edges with the grooves in.
■
Never allow metal objects, such as screws, staples and paper clips, to
enter the computer or keyboard. Foreign metal objects can create a
short circuit, which can cause computer damage and fire, possibly
resulting in serious injury.
■
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
Take care to ensure that the memory module cover is firmly closed.
Screw
Memory module
cover